[DeArmin]

I discovered today that it’s possible to scroll pages even when “Single Page” is selected in “Select Display Mode.” Until now, I thought scrolling was only possible if “Vertical Scrolling” was enabled.
The fact that scrolling also works in “Single Page” mode is an advantage for me → there are no page breaks. In most cases (about 90%), setting “Page Height” up to 5000 is sufficient. However, I now have a few medleys that are quite long and get cut off at “Page Height” = 5000.
Would it be possible to increase the value to 10000?

[Zubersoft]

Are we referring to the page size setting? What page scaling mode do you have selected? The page is always going to be scaled to fit the screen regardless of the dimensions you enter. If you are entering a page height of 5000, I can only assume you are setting the page scaling mode to "Fit Width". The main problem here is that an image still has to be rendered based on the dimensions you specify, and when the height gets too large, the file has to be spilt into tiles, so you can run into performance issues on some devices. I'll have to run some tests to see if increasing the max allowed value results in any major problems. I don't really see any issue with allowing this though, so I'll most likely make the change, as it's a very simple one, and if users run into issues, they can just lower the setting they've selected.

Mike

[DeArmin]

Are we referring to the page size setting? What page scaling mode do you have selected? The page is always going to be scaled to fit the screen regardless of the dimensions you enter. If you are entering a page height of 5000, I can only assume you are setting the page scaling mode to "Fit Width". The main problem here is that an image still has to be rendered based on the dimensions you specify, and when the height gets too large, the file has to be spilt into tiles, so you can run into performance issues on some devices. I'll have to run some tests to see if increasing the max allowed value results in any major problems. I don't really see any issue with allowing this though, so I'll most likely make the change, as it's a very simple one, and if users run into issues, they can just lower the setting they've selected.

Mike

Are we referring to the page size setting? Yes, "Enter the page Dimensions"

What page scaling mode have you selected? Tablet orientation = Portrait
Scale Mode = Full Screen
 
As an example where it works for me, here's a medley with these settings:
Under "Set to Screen," my Width=1600 and Height=2458 are displayed. I set the Height to 3755 for a medley and then enlarged the window so that the font size is optimal for me. Under "Apply Zoom/Pan Settings," I activated the following:
-enable pinch zoom gesture
-enable high-quality zooming
and under text and chordPro file zoom mode, I set it to „change page size“